I. Small Network Implementation
- Review Lab: Review of a Small Network Environment
II. Medium-Sized Switched Network Construction
- Implementing VLANs and Trunks
- Improving Performance with Spanning Tree
- Routing Between VLANs
- Securing the Expanded Network
- Troubleshooting Switched Networks
III. Medium-Sized Routed Network Construction
- Reviewing Routing Operations
- Implementing VLSM
IV. Open Shortest Path First
- Implementing Single Area OSPF
- Troubleshooting OSPF
V. Enhanced Interior Gateway Routing Protocol (EIGRP)
- Implementing EIGRP
- Troubleshooting EIGRP
VI. Access Control Lists (ACLs)
- ACL Operation
- Configuring and Troubleshooting ACLs
VII. Address Space Management
- Scaling the Network with NAT and PAT
- Transitioning to IPv6
VIII. LAN Extension into a WAN
- Establishing a Point-to-Point WAN Connection with PPP
- Establishing a WAN Connection with Frame Relay
- Troubleshooting Frame Relay WANs
- VPN Solutions
Labs
Lab 1: Implementing a Small Network (Review Lab)
Configure your workgroup switch and router with a basic configuration based on the network information provided.
Lab 2: Configuring Expanded Switch Networks
Expand the switch configuration to meet specific VLAN and network requirements.
Lab 3: Troubleshooting Switched Networks
Use troubleshooting methods discussed to diagnose, isolate, and correct problems commonly found in a switched network.
Lab 4: Implementing OSPF
Configure your workgroup routers to use the dynamic routing protocol OSPF.
Lab 5: Troubleshooting OSPF
Use troubleshooting methods discussed to diagnose, isolate, and correct problems commonly found when running the OSPF routing protocol.
Lab 6: Implementing EIGRP
Configure your workgroup routers to migrate from OSPF to EIGRP.
Lab 7: Troubleshooting EIGRP
Use troubleshooting methods discussed to diagnose, isolate, and correct problems commonly found when running the EIGRP routing protocol.
Lab 8: Implementing and Troubleshooting Access Control Lists (ACLs)
Create and troubleshoot IP ACLs.
Lab 9: Configuring NAT and Port Address Translation (PAT)
Configure your workgroup router to use PAT.
Lab 10: Implementing IPv6
Allocate and configure IPv6 addresses on your workgroup routers.
Lab 11: Establishing a Frame Relay WAN
Using the serial interface, create a Frame Relay connection to the Core.
Lab 12: Troubleshooting Frame Relay WANs
Use troubleshooting methods discussed to diagnose, isolate, and correct problems commonly found in a Frame Relay network.